The Body Bar Rectangle Silicone Mold is the perfect sized bar to use in the shower. The 7 oz rounded rectangle has smooth edges that fit perfectly in the hand. This Silicone mold has four lipped cavities that allow the rounded edges to be easily poured. Personalize this body bar by using a soap stamp!

Country Of Origin: China

Helpful Product Information:

• Style: Bar
• Avg. Bar Weight: 7 oz
• Bar Depth: 1.25"
• Bar Length: 3.75"
• Bar Width: 2.25"
• Container Size (oz.): 28
• Max Temperature: 500ºF

Common Uses:

Melt & Pour Soap (MP). Cold Process Soap (CP). Cold Process Oven Process Soap (CPOP). Hot Process Soap (HP). Lotion Bars.

Points of Interest:

• Maximum Temperature: 500ºF
• Manufacturer: Crafter’s Choice®
• Material: Silicone
• Country of Origin: China
• International Nomenclature of Cosmetic Ingredients (INCI): This product does need to be listed on the product ingredient label.
• Common Name Ingredient Listing (FDA Approved): This product does need to be listed on the product ingredient label.

Directions:

Melt & Pour Soap: Pour melted soap into silicone mold cavities. Allow soap to cool at room temperature until hard. Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold.

Cold Process Soap: Pour soap at trace into the mold cavities. After at least 24 hours, gently pull silicone mold to loosen its grip on the soap. Flip mold over onto a clean surface and gently push on the bottom of mold until the soap starts to release. Grab hold of the soap with a gloved hand, and allow soap to cure for 4-8 weeks. Note that some cold process soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.

Cold Process/Oven Process Soap: Pour soap at trace into the mold cavities. Preheat oven to 170ºF then place mold in oven. Turn oven off, and keep soap in oven overnight. The next day remove mold from oven. Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold. Allow soap to cure for 2 to 4 weeks.

Hot Process Soap: Scoop hot process soap into mold cavities. Gently tap the mold onto the counter to remove air pockets. Allow soap to cool and harden. (This can take up to 48 hours.) Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold.

Lotion Bars: Pour melted lotion bar mixture into mold cavities. Allow mixture to solidify. Carefully remove lotion bars from mold by gently pulling the sides away from the lotion bars, and then push on the bottom of the mold until the lotion bars starts to release. Grab hold of lotion bar and carefully pull out of mold.

Care: Hand wash in warm sudsy water.